What are the requirements for customs container supervision? In this issue’s article, Jiutong IOT’s Xiaobian will introduce you to everyone:
1. The structure of the box (car) is tight and complete, and the sealing part of the box (car) can be applied with customs seals. If the goods are taken out or loaded by illegal means, the customs seal will be damaged, or the opening and tearing marks will be left outside the box.
(1) The assembly methods of the components (end wall, side wall, bottom plate, door, roof, corner column, longitudinal girders, beams, etc.) of the box (carriage) body shall be guaranteed not to be moved or exchanged from the outside of the box (carriage) body. Its components may change its structure, otherwise it will leave visible visible traces.
(2) When the top (body), side wall, bottom plate and door of the box are composed of different parts, these parts shall meet the above requirements and have sufficient strength.
The cabinet should have no hidden parts
2. The box (carriage) body should have no hidden parts for hiding goods.
(1). Where the composite parts are structurally necessary to leave the necessary clearances (for example, the gap between the double-wall panels), but in order to prevent these parts from being used for hiding goods, the liner inside the box body should not be moved or exchanged. Otherwise, it will leave a visible visible trace.
(2). In order to facilitate customs inspection, the number of structures with voids mentioned above should be kept to a minimum.
Customs seals can be applied to the cabinet
3. The customs seal can be applied to the box (box) simply and effectively.
(1). The box (carriage) door and other closing parts (including the cut-off cock, manhole cover, flange, etc.) shall be equipped with a device that can easily and effectively apply the customs seal, and its structural design shall ensure that the box (car) body cannot be removed. Externally open the door and all other closing devices, otherwise the customs seal will be destroyed.
(2). The vent hole and the drain hole of the box body should be equipped with a protective cover or the like to prevent the vent hole and the drain hole from entering the inside of the box body. The protective cover or the like cannot be moved or exchanged from the outside of the box body, otherwise a visible trace will be left.
Recommended reading “Emirates Police Department fully activates Jiutong IOT Intelligent Electronic Lock JT701″
Post time: Jul-31-2018